336E Excavator and 336E MHPU Mobile Hydraulic Power Unit Machine Systems Swing Motor - Remove and Install Caterpillar

Removal Procedure

Start By:

1. Release the hydraulic system pressure.

Show/hide table

Personal injury can result from hydraulic oil pressure and hot oil. Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system. Make sure all of the work tools have been lowered to the ground, and the oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.

Show/hide table

Illustration 1	g02138737

1. Remove the cap from the hydraulic tank. Install Tooling (A) onto the hydraulic tank. Attach an air supply hose to Tooling (A). Apply 276 to 414 kPa (40 to 60 psi) of air. This procedure will pull vacuum on the hydraulic system.
   Show/hide table

   Illustration 2	g02140979

2. Disconnect fitting assembly (1) and hose assemblies (2) from swing motor (3).
   Show/hide table

   Illustration 3	g02140980

3. Attach Tooling (B) and a suitable lifting device to swing motor (3). The weight of swing motor (3) is approximately 75 kg (165 lb). Remove bolts (4), swing motor (3), and the O-ring seal.

Installation Procedure

1. Install swing motor (3) in the reverse order of removal.