315C Excavator Machine Systems Stick Bearings and Seals

Stick Bearings and Seals - Remove

315C Excavator Machine Systems [RENR5525]

315C Excavator Machine Systems Bucket Linkage Bearings and Seals - Install

315C Excavator Machine Systems Stick Bearings and Seals - Install

IMPLEMENTS

STICK GP

315B Excavator Excavator Systems Stick - Remove

315B Excavator Excavator Systems Stick - Install

315C Excavator Machine Systems Stick Bearings and Seals - Remove

315C Excavator Machine Systems Stick Bearings and Seals - Install

1.1. Removal Procedure

Removal Procedure

Show/hide table

Table 1
Required Tools
Tool	Part Number	Part Description	Qty
A	3S-6224	Electric Hydraulic Pump	1
	8T-0820	Pressure Gauge	1
	3B-7722	Bushing	2
	1P-2376	Coupler Assembly	2
	1P-2377	Plug	2
	8F-0024	Hose Assembly	2
	9U-5346	Fast Runner Nut Assembly	1
	5P-8712	Bushing	1
	4C-9634	Puller Stud	1
	6V-0113	Cylinder	1
	9U-5266	Receiving Sleeve	1
	9U-5337	Bearing Puller Adapter	1
B	3S-6224	Electric Hydraulic Pump	1
	8T-0820	Pressure Gauge	1
	3B-7722	Bushing	2
	1P-2376	Coupler Assembly	2
	1P-2377	Plug	2
	8F-0024	Hose Assembly	2
	9U-5346	Fast Runner Nut Assembly	1
	5P-8712	Bushing	1
	4C-9634	Puller Stud	1
	6V-0113	Cylinder	1
	9U-5266	Receiving Sleeve	1
	9U-5338	Bearing Puller Adapter	1

Start By:

Remove the stick. Refer to Disassembly and Assembly, "Stick - Remove".

Show/hide table




Illustration 1	g00476726

Remove lip seals (1) from the stick at the pin joint for the bucket.

Use Tooling (A) to remove the bearings at the pin joint for the bucket. Fasten Tooling (A) to the stick. Fasten a suitable lifting device to Tooling (A) for support. Remove the bearing. Remove the bearing on the opposite side of the stick in the same manner.

Show/hide table




Illustration 2	g00476727

Remove lip seals (2) from the stick at the pin joint for the boom.

Show/hide table




Illustration 3	g00476728

Note: For the removal of the lip seals and the bearings from the stick at the pin joint for the bucket control linkage, refer to Disassembly and Assembly, "Bucket Linkage Bearings - Remove".

Use Tooling (B) to remove the bearings from the stick at the pin joint for the boom. Fasten Tooling (B) to the stick, as shown. Fasten a suitable lifting device to Tooling (B) for support. Remove the bearing. Remove the bearing on the opposite side of the stick in the same manner.