Swing Drive - Remove
`
315C Excavator Machine Systems
[RENR5525]
315C Excavator Machine Systems
Shuttle Valve - Remove - Auxiliary Control
315C Excavator Machine Systems
Swing Drive - Install
FRAME AND BODY
DRIVE GP-SWING
315B Excavator Excavator Systems
Swing Drive - Disassemble
315B Excavator Excavator Systems
Swing Drive - Assemble
315C Excavator Machine Systems
Swing Drive - Remove
315C Excavator Machine Systems
Swing Drive - Install
1.1. Removal Procedure
Removal Procedure
Show/hide table
| Required Tools | |||
|---|---|---|---|
| Tool | Part Number | Part Description | Qty |
| A | 138-7574 | Link Bracket | 2 |
| B | 154-6184 | 20 mm x 60 mm Forcing Screw | 2 |
Start By:
- Remove the swing motor. Refer to Disassembly and Assembly, "Swing Motor - Remove".
- Thoroughly clean the area around the swing drive prior to removal.
- Put identification marks on the swing drive in order to mark the drive's location for assembly purposes.
- Remove bolts (1) that hold the swing drive to the main frame.
Show/hide table
 | |
| Illustration 1 | g00363453 |
- Attach Tooling (A) and a suitable lifting device to swing drive (3), as shown.
- Remove corks (2) from the threaded holes in the swing drive housing. Install Tooling (B) in each threaded hole in the swing drive housing. Slowly tighten one forcing screw for a few turns. Tighten the other forcing screw for a few turns. Alternate between the forcing screws in this manner in order to separate the swing drive from the main frame.
- Remove swing drive (3) from the machine. The weight of swing drive (3) is approximately 115 kg (250 lb).
Information System:
315C Excavator Machine Systems
Shuttle Valve - Remove - Auxiliary Control
W345B Series II Material Handler Machine System Specifications
Swing Drive - Left Swing Drive and Right Swing Drive
315C Excavator Machine Systems
Pump Control - Install
345B Excavator
Equipment Lowering with Engine Stopped
315C Excavator Machine Systems
Pump Control - Remove
315C Excavator Machine Systems
Main Control Valve - Install
5130B Excavator
Fuses - Replace
5130B Excavator
Fuel Tank Water and Sediment - Drain
5230B Excavator
Reference Material
312C, 315C, 318C, 319C, 320C, 321C, 322C, 325C, 330C and M325C Excavators and 325C MHPU and 330C MHPU Mobile Hydraulic Power Units Engine and Pump Control - V2
Governor Actuator - Calibrate
320C, 322C and 325C Excavators Tool Control System
Using Caterpillar Electronic Technician to Determine Diagnostic Codes
120H and 135H Motor Graders
Engine Air Filter Primary Element - Clean/Replace
315C Excavator Machine Systems
Swing Drive - Install
315C Excavator Machine Systems
Shuttle Valve - Remove - Straight Travel
315C Excavator Machine Systems
Undercarriage Frame - Remove
315C Excavator Machine Systems
Shuttle Valve - Install - Straight Travel
315C Excavator Machine Systems
Track Carrier Roller - Install
315C Excavator Machine Systems
Undercarriage Frame - Install
315C Excavator Machine Systems
Pilot Valve (Implement) - Remove
315C Excavator Machine Systems
Pilot Valve (Implement) - Disassemble
315C Excavator Machine Systems
Pilot Valve (Implement) - Install
315C Excavator Machine Systems
Pilot Valve (Implement) - Assemble
315C Excavator Machine Systems
Shuttle Valve - Install - Auxiliary Control
315C Excavator Machine Systems
Pilot Valve (Travel) - Remove