Pump Control - Install
`
315C Excavator Machine Systems
[RENR5525]
315C Excavator Machine Systems
Pump Control - Remove
315C Excavator Machine Systems
Shuttle Valve - Remove - Auxiliary Control
HYDRAULIC SYSTEM
PUMP GP
315C Excavator Machine Systems
Main Hydraulic Pump - Disassemble
315C Excavator Machine Systems
Main Hydraulic Pump - Assemble
315C Excavator Machine Systems
Pump Control - Disassemble
315C Excavator Machine Systems
Pump Control - Assemble
315C Excavator Machine Systems
Main Hydraulic Pump - Remove
315C Excavator Machine Systems
Gear Pump (Pilot) - Remove and Install
315C Excavator Machine Systems
Main Hydraulic Pump - Install
1.1. Installation Procedure
Installation Procedure
Note: Check the O-ring seals for wear or for damage. Replace the O-ring seals, if necessary.
Show/hide table
| NOTICE |
|---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Place pump control (5) in position on the main hydraulic pump. Secure the pump control in position with bolts (4) .
Show/hide table
 | |
| Illustration 1 | g00805069 |
- Connect hose assembly (3), and connect harness assembly (1). Install bolt (2) which secures the clip and harness assembly (1) .
Show/hide table
 | |
| Illustration 2 | g00805073 |
- Close the right, rear door for the pump compartment.
- Fill the hydraulic system with oil. Refer to the Operation and Maintenance Manual, "Lubricant Viscosities and Refill Capacities" and refer to Operation and Maintenance Manual, "Hydraulic System Oil Level - Check".
Information System:
345B Excavator
Equipment Lowering with Engine Stopped
315C Excavator Machine Systems
Pump Control - Remove
315C Excavator Machine Systems
Main Control Valve - Install
5130B Excavator
Fuses - Replace
5130B Excavator
Fuel Tank Water and Sediment - Drain
5230B Excavator
Reference Material
312C, 315C, 318C, 319C, 320C, 321C, 322C, 325C, 330C and M325C Excavators and 325C MHPU and 330C MHPU Mobile Hydraulic Power Units Engine and Pump Control - V2
Governor Actuator - Calibrate
320C, 322C and 325C Excavators Tool Control System
Using Caterpillar Electronic Technician to Determine Diagnostic Codes
120H and 135H Motor Graders
Engine Air Filter Primary Element - Clean/Replace
5130B Excavator
Fuel System - Prime
315C Excavator Machine Systems
Pressure Reducing Valve - Remove and Install
320C, 322C and 325C Excavators Tool Control System
MID 069 - CID 1590 - FMI 06
W345B Series II Material Handler Machine System Specifications
Swing Drive - Left Swing Drive and Right Swing Drive
315C Excavator Machine Systems
Shuttle Valve - Remove - Auxiliary Control
315C Excavator Machine Systems
Swing Drive - Remove
315C Excavator Machine Systems
Swing Drive - Install
315C Excavator Machine Systems
Shuttle Valve - Remove - Straight Travel
315C Excavator Machine Systems
Undercarriage Frame - Remove
315C Excavator Machine Systems
Shuttle Valve - Install - Straight Travel
315C Excavator Machine Systems
Track Carrier Roller - Install
315C Excavator Machine Systems
Undercarriage Frame - Install
315C Excavator Machine Systems
Pilot Valve (Implement) - Remove
315C Excavator Machine Systems
Pilot Valve (Implement) - Disassemble
315C Excavator Machine Systems
Pilot Valve (Implement) - Install