CS56B, CP56B, CS66B, CS68B and CP68B Vibratory Soil Compactors Machine Systems Control Valve (Shift) - Assemble Caterpillar

Assembly Procedure

Note: Cleanliness is an important factor. Before assembly, all parts should be thoroughly cleaned in cleaning fluid. Allow the parts to air dry. Wiping cloths or rags should not be used to dry parts. Lint may be deposited on the parts which may cause later trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement.

Show/hide table

Illustration 1	g00803398

1. Install O-ring seals (5) and backup ring (6) on valve cartridge (4).
   Show/hide table

   Illustration 2	g00803397

2. Install valve cartridge (4) in valve body (1). Tighten the valve cartridge to a torque of 37 N·m (27 lb ft).
   Show/hide table

   Illustration 3	g00803396

3. Install coil (2) and nut (3) on the valve cartridge and valve body (1). Tighten the nut to a torque of 4 N·m (35 lb in).

End By:

1. Install the control valve (shift). Refer to Disassembly and Assembly, "Control Valve (Shift) - Install".