Stopping the Engine
`
305 CR Mini Hydraulic Excavator
[SEBU7428]
ENGINE ARRANGEMENT
305 CR Mini Hydraulic Excavator
Stopping the Engine
305 CR Mini Hydraulic Excavator
Engine Starting
301.5, 301.6 and 301.8 Mini Hydraulic Excavators
Engine Starting with Jump Start Cables
303.5E2, 304E2, 305.5E2 and 305E2 Mini Hydraulic Excavators
Engine and Machine Warm-Up
303.5 Mini Hydraulic Excavator
Reference Material
1.1. Stop the Engine if an Electrical Malfunction Occurs
Show/hide table
| NOTICE |
|---|
Stopping the engine immediately after it has been working under load can result in overheating and accelerated wear of engine components. Refer to the following procedure to allow the engine to cool and to prevent excessive temperatures in the turbocharger housing, which could cause oil coking problems. |
- Stop the machine and run the engine at low idle for five minutes.
- Turn the engine start switch to the OFF position and remove the engine start switch key.
Show/hide table
 | |
| Illustration 1 | g00810984 |
Stop the Engine if an Electrical Malfunction Occurs
Lower the work tool and the blade to the ground. Turn the engine start switch key to the OFF position. If the engine does not stop, perform the following procedure.
- Open the engine access panel that is located in the rear of the machine.
- Push the button for the fuel shutoff valve and hold the button until the engine shuts off.
Show/hide table
 | |
| Illustration 2 | g00811170 |
Note: Do not operate the machine again until the malfunction has been corrected.
Information System:
312C Excavator 3064 Engine Supplement
Radiator - Remove
446B Backhoe Loader Transmission (Autoshift)
Machine Preparation for Troubleshooting
385B Excavator
Adjustable Gage Undercarriage Frame
325C Excavator
Safety Messages - Arrangement I
3500B Engines
Jacket Water Cooling Circuit
312C Excavator 3064 Engine Supplement
Expansion Tank - Remove and Install
385B Excavator
Boom, Stick and Bucket Linkage - Lubricate
5230B Excavator Electronic Systems Guide
Diagnostic Code List
2002/01/07
A New Exhaust Seal And A New Exhaust Manifold Sleeve Are Used In The Exhaust Manifold Groups {1059}
HDB Series and M1 Series Heavy Duty Brushless Alternators
Alternator
385B Excavator
Main Menu
385B Excavator
Monitoring System
W345B Series II Material Handler Hydraulic System
Electronic Control System
446B Backhoe Loader Transmission (Autoshift)
Visual Inspection
385B Excavator
Gain/Response Control
CONVERSION CHART{0374}
3064 and 3066 Engines for Caterpillar Built Machines
Finding Top Center Position for No. 1 Piston
325C and 325C L Excavator
Battery Disconnect Switch
345B Series II Excavator Hydraulic System
Pilot Hydraulic System
385B Excavator
Safety Messages - Arrangement I
2001/07/16
New Electronic Tachometers Have Different Connection To Wiring Harness {7462}
303.5E2, 304E2, 305.5E2 and 305E2 Mini Hydraulic Excavators
Parking
Chart for Heli-Coil Repair {0676}
5230B Excavator Hydraulic System
Piston Pump (Hydraulic Cooling) - Test and Adjust