330C Material Handler Fuses - Replace Caterpillar


Fuses - Replace
`
330C Material Handler [SEBU7671]
ELECTRICAL AND STARTING SYSTEM
BATTERY GP
330C Material Handler Fuses - Replace

Open the rear access door on the left side of the machine.

The fuse panel is located on the circuit breaker panel. Open the cover for access to the fuses.


Fuses - Fuses protect the electrical system from damage that is caused by overloaded circuits. Change a fuse if the element separates. If the element of a new fuse separates, check the circuit and/or repair the circuit.


NOTICE

Always replace fuses with the same type and capacity fuse that was removed. Otherwise, electrical damage could result.



NOTICE

If it is necessary to replace fuses frequently, an electrical problem may exist.

Contact your AVSpare dealer.


To replace a fuse, use the puller that is stored in the fuse panel. Three fuses of 5 Amperes, four fuses of 10 Amperes, two fuses of 15 Amperes, and one fuse of 30 Amperes are contained in the fuse panel as spare fuses.

The following list identifies the circuits that are protected by each fuse. The amperage for each fuse is included with each circuit.




Illustration 1g00886730

(1) Spare - 5 Amp

(2) Spare - 10 Amp

(3) Spare - 10 Amp

(4) Spare - 15 Amp

(5) Spare - 15 Amp

(6) Spare - 30 Amp

(7) Product Link - 10 Amp

(8) Engine Controller - 15 Amp

(9) Horn and Quick Coupler - 10 Amp

(10) Timer Relay - 10 Amp

(11) Cab Lamp - 10 Amp

(12) Engine Start Switch - 10 Amp

(13) Boom Light - 10 Amp

(14) Engine Controller and Pump Controller - 10 Amp

(15) Controller for Attachment Valve - 15 Amp

(16) Dome Lamp and Memory - 10 Amp

(17) Air Conditioner Blower - 15 Amp

(18) Electric Refueling Pump - 30 Amp

(19) Spare - 5 Amp

(20) Spare - 5 Amp

(21) Spare - 10 Amp

(22) Inspection Lamp - 10 Amp

(23) Fuel Pump - 10 Amp

(24) Windshield Washer and Windshield Wiper - 15 Amp

(25) Chassis Light - 10 Amp

(26) Backup Switches and Monitor Controller - 5 Amp

(27) Seat Heater - 5 Amp

(28) Auxiliary Circuit - 10 Amp

(29) Cigar Lighter - 10 Amp

(30) Switch Panel and Radio - 5 Amp

(31) Attachment Solenoid - 10 Amp

(32) 12 Volt 7 Amp Converter 1 - 10 Amp

(33) Auxiliary Circuit - 10 Amp

(34) Air Conditioner - 15 Amp

(35) Spare - 5 Amp

(36) Beacon Light - 15 Amp

(37) Auxiliary Circuit - 5 Amp

(38) Auxiliary Circuit - 10 Amp

Information System:

385B Excavator Swing Drive Oil - Change
312C Excavator 3064 Engine Supplement V-Belts - Remove and Install
385B Excavator Refrigerant Dryer - Replace
385B Excavator Hydraulic Tank Screen - Clean
385B Excavator Hydraulic System Oil Level - Check
330C Excavator Boom/Stick/Bucket Combinations
2001/07/23 New Dump Cylinder Tubes are Available {5057}
385B Excavator Hydraulic System Oil Filter (Case Drain) - Replace
312C Excavator 3064 Engine Supplement Electric Starting Motor - Remove and Install - Engine In Chassis
385B Excavator Hydraulic System Oil Filter (Pilot) - Replace
5230B Excavator Hydraulic System Boom, Bucket, Stick, Swing and Travel Cycle Times
3126B Engine for Caterpillar Built Machines Digital Sensor Supply Circuit - Test
446B Backhoe Loader Transmission (Autoshift) Transmission Hydraulic System
Procedure to Rework the Return Lines for the Margin Relief Valve{5057, 5069}
330C Excavator Engine Oil Level - Check
3126B Engine for Caterpillar Built Machines Electrical Power Supply Circuit - Test
312C Excavator 3064 Engine Supplement Alternator - Remove and Install
W345B Series II Material Handler Machine System Specifications Control Valve (Main)
446B Backhoe Loader Transmission (Autoshift) Transmission Control
5230B Excavator Electronic Systems Guide Location of Sensors
320C, 322C and 325C Excavators Tool Control System System 1: Relief Valve (Line) - Test and Adjust - Work Tool
320C, 322C and 325C Excavators Tool Control System System 1: Solenoid Valve (Proportional Reducing) - Calibrate - Negative Flow Control
320B, 320B L and 320B N Excavators Travel in Water and Mud
345B Series II Excavator Engine Speed Control