385B Excavator Cooling System Coolant Level - Check Caterpillar

Show/hide table

Illustration 2	g00561175

1. Open the access door for the cooling system pressure cap.

2. Slowly loosen the cooling system pressure cap in order to relieve system pressure. Remove the pressure cap.

   Note: Refer to Operation and Maintenance Manual, "General Hazard Information" for information on containing fluid spillage.

3. Add the appropriate coolant solution to the cooling system. Refer to the following topics:

   • Special Publication, SEBU6250, "AVSpare Machine Fluids Recommendations", "Cooling System Specifications"

   • Operation and Maintenance Manual, "Capacities (Refill)"

4. Start the engine. Operate the engine without the cooling system pressure cap until the water temperature regulator opens and the coolant level stabilizes.

5. Maintain the coolant level within 13 mm (0.5 inch) of the bottom of the filler pipe.
   Show/hide table

   Illustration 3	g00102170

6. Inspect the condition of the gasket on the pressure cap. If the gasket is damaged, replace the pressure cap.

7. Install the cooling system pressure cap.

8. Stop the engine.

9. Close the access cover for the cooling system pressure cap.

Note: Refer to Operation and Maintenance Manual, "General Hazard Information" for information on containing fluid spillage.