| |
| Illustration 1 | g06018914 |
|
Typical example | |
Note: Demolition Tools, such as Hammers & Shears, are strictly prohibited for use on the BH150 / BH160 as a result of CE Certification.
There are several specific safety messages on this work tool. The exact location of the hazards and the description of the hazards are reviewed in this section. Please become familiarized with all safety messages.
Make sure that all of the safety messages are legible. Clean the safety messages or replace the safety messages if you cannot read the words. Replace the illustrations if the illustrations are not legible. When you clean the safety messages, use a cloth, water, and soap. Do not use solvent, gasoline, or other harsh chemicals to clean the safety messages. Solvents, gasoline, or harsh chemicals could loosen the adhesive that secures the safety message. Loose adhesive will allow the safety message to fall.
Replace any safety message that is damaged, or missing. If a safety message is attached to a part that is replaced, install a new safety message on the replacement part. Any AVSpare dealer can provide new safety messages.
This safety message is located on the hose guard.
| |
| Illustration 2 | g01370904 |
 |
|
Do not operate or work on this machine or work tool unless you have read and understand the instructions and warnings in the Operation and Maintenance Manuals and Owner's Manuals. Failure to follow the instructions or heed the warnings could result in injury or death. Contact your AVSpare dealer for replacement manuals. Proper care is your responsibility. |
This safety message is located on the hose guard.
| |
| Illustration 3 | g03621996 |
|
|
Crush injury. Could cause serious injury or death. Always confirm Quick Coupler pins are engaged. Refer to the Operation and Maintenance Manual. |
This safety message is located on both sides of the boom.
| |
| Illustration 4 | g01371644 |
|
|
No clearance for person in this area during operation. Severe injury or death from crushing could occur. Stay away from the work tool while it is in operation. |
This safety message is located on both of the housings for the stabilizers.
| |
| Illustration 5 | g01434592 |
|
|
No clearance for person in this area during operation. Severe injury or death from crushing could occur. Stay away from the work tool while it is in operation. |