814 Wheel Dozer Differential and Final Drive Oil Level - Check Caterpillar


Differential and Final Drive Oil Level - Check
`
1.1. Front Axle
2.1. Rear Axle

------ WARNING! ------

Pressurized system: Hot oil can cause serious burns. To open plug, stop engine, wait until axle is cool. Then loosen plug slowly to relieve the pressure.


Note: Before you measure the oil level, operate the machine for a few minutes to equalize the oil level.

Front Axle



Illustration 1g01063905
The location of the filler plug (1) for the front axle differential.

  1. Remove the front differential filler plug (1). The position of the plug is shown in the above illustration.

  2. Fill the front axle with oil and maintain the oil level to the bottom of the filler plug. Refer to Operation and Maintenance Manual, "Capacities (Refill)" for information on the capacities of the axles.

  3. Install the front differential filler plug (1). Tighten to a torque of 45 ± 6 N·m (33 ± 4 lb ft).

Rear Axle



Illustration 2g06273974
The location of the filler plug (2) for the rear axle differential.

  1. Remove the rear differential filler plug (2). The position of the plug is shown in the above illustration.

  2. Fill the rear axle with oil and maintain the oil level to the bottom of the filler plug. Refer to Operation and Maintenance Manual, "Capacities (Refill)" for information on the capacities of the axles.

  3. Install the rear differential filler plug (1). Tighten to a torque of 45 ± 6 N·m (33 ± 4 lb ft).

Information System:

814 Wheel Dozer Differential and Final Drive Oil - Change
816K Landfill Compactor Sound Information and Vibration Information
300.9D VPS Mini Hydraulic Excavator Machine Systems Return Hydraulic System
312F and 313F Excavator Machine Systems Swing System
990K Wheel Loader and 844K Wheel Dozer Machine Systems Seat - Remove and Install
349D2 MHPU Mobile Hydraulic Power Unit Hydraulic System Pilot Hydraulic System
C2.4 Tier 4 Final Engines for Caterpillar Built Machines Crankshaft Gear - Remove and Install
349D2 MHPU Mobile Hydraulic Power Unit Hydraulic System Main Hydraulic System
C2.4 Tier 4 Final Engines for Caterpillar Built Machines Camshaft - Remove and Install
325F Excavator Machine Systems Drift Reduction Valve (Stick) - Remove and Install
349D2 MHPU Mobile Hydraulic Power Unit Hydraulic System Specifications
New Machine Software is Now Used on Certain Excavators {7610, 7620}
314F and 315F Excavators Machine Systems Pilot System
314F and 315F Excavators Machine Systems Swing System
349D2 MHPU Mobile Hydraulic Power Unit Hydraulic System Main Hydraulic Pump
PM620, PM622, PM820, PM822 and PM825 Cold Planers Electronic System Speed Signal - Test
349D2 MHPU Mobile Hydraulic Power Unit Hydraulic System Main Control Valve
300.9D VPS Mini Hydraulic Excavator Machine Systems Boom Hydraulic System
349D2 MHPU Mobile Hydraulic Power Unit Hydraulic System Negative Flow Control System
300.9D VPS Mini Hydraulic Excavator Machine Systems Bucket Hydraulic System
300.9D VPS Mini Hydraulic Excavator Machine Systems Stick Hydraulic System
349D2 MHPU Mobile Hydraulic Power Unit Hydraulic System Relief Valve (Main)
312F and 313F Excavator Machine Systems Travel System
Exhaust Gas Valve (NRS) for C7.1, and C6.6 Engines {5137}